| Changhua Chen Ying Oil Machine Co., Ltd. |
|
| |
| |
|
| |
| |
 |
|
Features:
1.According to the difference of flow rate, there are CLS-10, CLS-30, CLS-50 type, among them, CLS-50 has largest flow rate 4.5 L/min, please refer the specification for details.
2.CLS type is circulating lubricator, which means the oil flows out, then comes back into the oil tank through the cyclic inlet. The cyclic inlet has magnetic filter, which can block the impurities and assure the oil clean.
3.After installing and connecting the piping, feed oil till oil flows out, then start to use this lubricator.
4.It used a high quality pump that not only has steady output pressure and low noise, but also can assure each lubrication point with output of oil. It can be applied for large machines' request.
5.It has a pressure switch device, which assures the oil volume of lubrication point and detects if the piping works normally. The standard specification is NC (Normal Close) contact, which means if the pressure is abnormal, it will have abnormal signal. NO (Normal Open) contact is on request.
6.It has a pressure-regulating valve, which can adjust the pressure and easy to check from the pressure gauge.
7.It has a float switch that can detect the oil volume. It will have an automatic signal when the oil level is lower than the minimum.
8.The standards assemble with 1/2 HP motor, also can be changed to 1 HP.
9.The standard of cyclic inlet is 3/4 inches, but can be changed to 1, 1 1/4, 1 1/2 inches on request.
10.A buzzer can be added on request, which will alarm when the oil level is lower than the minimum. |
|
|
|
|
| |
|
|
| |
| |
 |
|
circulatingelectriclubricator0587.jpg)
